How Do I Setup My Shade/Motor?

1. Pair your motorized shade with your remote

Select a channel on your remote.

Note: Consult the user manual for your controller for more information on selecting channels.

Hold the P1 button on the motor until it jogs back and forth once.

Note: For help finding the P1 button on your motor, see Motor (P1) Button Locations & Functions

Hold the STOP button on your remote until your shade jogs twice

Motor is now in step mode and ready for setting limits

2. Check the motor direction

To check the motor direction, press UP or DOWN on controller

Single Tap = Step (shade will inch and then stop)

Long Press = Continuous Travel (shade will continue moving until STOP is pressed)

Warning: Damage to shade may occur when operating motor prior to setting limits. Attention should be given.

If the direction is correct, then continue by setting limits. If not, reverse the direction by holding both UP and

DOWN, until the shade jogs once.

Note: Reversing the motor direction using the remote is only possible during initial set-up (before limits have been set for the first time).

3. Set the upper limit 

Important: Upper limit must be set first.

Move the shade UP or DOWN to adjust the shade to your desired upper limit.

Hold UP and STOP until the shade jogs twice. The upper limit is now saved.

4. Set the lower limit

Move the shade UP or DOWN to adjust the shade to your desired lower limit.

Hold DOWN and STOP until the shade jogs twice. The lower limit is now saved.

5. Lock your remote (Optional - Recommended)

For more information, see How to Lock and Unlock your Remote