Zipscreen Spring Control
Installation Video
Step-by-step guide
Align control hardware
Align the control hardware with the bracket and ensure the tube assembly is engaged.
Insert Shade
Install the Shade by fitting the Spring Control end onto the bracket first and then connecting the bearing idler into place on the opposite side.
Prepare drill
Use a drill with a 1/4” hex bit.
Do not use an impact driver.
Insert the drill
The drill will engage smoothly if inserted at the correct angle.
Activate pin
Push against the spring-loaded pin (roughly 5mm deep) before attempting to add or remove tension.
Add or remove spring tension
Engage the drill clockwise to apply tension. Anticlockwise will remove tension. The weight bar will move up slightly when enough pre-turns have been applied. Tension can be adjusted at any time, even while unlocked.
Unlock the Spring to operate the shade
Push the grey lock to the unlocked position. The lock button will remain fully retracted.
If the lock does not retract, ensure the spring head is flush against the bracket adaptor.
